USA Epoxy Floors levels concrete floors by grinding high spots and filling low areas using precision tools and leveling compounds. This service delivers a flat, finished slab ready for coatings, tile, carpet, or polished concrete in Denning.
Every Denning floor leveling job with USA Epoxy Floors begins with an assessment using laser levels and straightedges to map out high and low spots across the slab. George Tsinias, owner of USA Epoxy Floors, checks for moisture issues and reviews previous repairs or patches common in older Ulster County properties to determine the right preparation method. Grinding equipment equipped with industrial diamond tooling flattens the surface, while self-leveling compounds and engineered patches are installed in low areas. All products are applied to specification, with careful feathering at transitions for a seamless finish. This method is used ahead of resinous coating installations, tile, carpet, or as a prep step for polished concrete. Once the surface cures and final checks are made for flatness and level, the floor is cleaned and ready for the next construction stage or final finishing. The process produces a true, level substrate on residential and commercial sites in Denning and throughout Ulster County, suitable for any type of finished flooring system.
USA Epoxy Floors uses diamond grinders in Denning for accurate removal of slab high points and irregularities before any leveling material is installed. This mechanical approach supports a flat surface profile and strong primer adhesion, eliminating future delamination risks in Ulster County.
George applies self-leveling compounds that match the substrate condition and intended finish, ensuring flatness from edge to edge. In Denning, these materials are expertly blended for durability and feathered where needed to avoid cracks and uneven seams in the finished floor.
George Tsinias personally evaluates every Denning floor, identifies underlying issues like moisture or prior bad patches, and maps out the leveling approach. This diagnostic step prevents hidden problems from causing failures after new flooring goes down in Ulster County.
Fill in your information below
USA Epoxy Floors delivers concrete floor leveling for residential and commercial properties in Denning, providing a flat, finished base for any type of new flooring or coating. George Tsinias, owner of USA Epoxy Floors, brings over 25 years of experience diagnosing and correcting uneven, sloped, or deteriorated concrete by combining grinding and leveling compounds. As a locally owned, family-run, and veteran-owned business, the company is the specialist contractors and property owners in Ulster County depend on for expert substrate leveling before epoxy, tile, carpet, or polished finishes.
More About Us
Yes. Denning and communities across Ulster County, New York. USA Epoxy Floors has been doing this work since 2001 and travels throughout the region for it, residential and commercial alike.
The space is cleared, the slab is inspected and profiled mechanically, repairs go in, and the coating system is applied in stages. Cure windows between coats are part of the schedule, not delays. At the end the floor is walked through together before the job closes.
Usually. The existing coating comes off mechanically, and the slab underneath is inspected to identify why the previous system failed. Poor preparation and moisture vapor account for most failures. The cause is addressed before a new system goes down.
It depends on the floor. Epoxy builds thicker and bonds deep; polyaspartic cures quickly, tolerates colder installs, and resists UV yellowing. Many jobs use an epoxy base under a polyaspartic topcoat. The specification follows the slab inspection, the moisture readings, and how the space is used.
Frequently. Polyaspartic chemistry cures across a wider temperature range than standard epoxy, which makes cold-weather work viable in many unheated Denning spaces. Substrate temperature is the controlling factor and gets checked before scheduling.
Reach out at (845) 464-2539 or through the estimate form with the square footage and a description of the space. George Tsinias comes to Denning, walks the floor, and quotes on the spot.
“4 other contractors showed up, did their pitch, and then had to "go back to the office to prepare a quote" - 2 of them never responded and the other two estimates seemed high - George on the other hand showed up, gave me my options and provided a written quote right on the spot that was about 15% less than the other quotes and went on to do a superb job on my garage floor. I would recommend him highly!”
“We are so happy to have discovered George Tsinias. He is an old school artisan and gentleman who takes pride in his work, takes every issue seriously, answers every question, and is a meticulous workman. The garage floor he did for us is stunning. He is humble, fun, courteous, friendly, extremely knowledgeable about adjacent trades and competent in several of them. I am delighted to give him the highest recommendation and look forward to referring him to friends and to using him again.”
“When we called George to give us an estimate on our basement , we knew he was the right guy. He did such a good job in a basement. Then we had him do our two garages. He will never leave a job unless the customer is 100% satisfied. He takes pride in his work. He is a GREAT person to deal with and very responsive and very reasonable.”
“I recently had my basement floor done by USA Epoxy Floors in Fishkill, NY, and I couldn’t be happier with the results. George did an outstanding job from start to finish. He was professional, knowledgeable, and took the time to explain the entire process. The quality of the workmanship is exceptional, the floor came out absolutely beautiful and exceeded my expectations. The attention to detail was impressive, and it’s obvious that George takes great pride in his work. On top of that, the price was very reasonable, especially considering the quality of the finished product. If you’re looking for a company that delivers excellent craftsmanship, great customer service, and fair pricing, I highly recommend USA Epoxy Floors. Thanks again, George, for transforming my basement. It looks fantastic!”
“USA epoxy in Fishkill, New York is one of the greatest epoxy companies I've ever had to deal with George the owner and his crew were amazing. Doing my two floor car garage. The job was finished as promised on time very clean and very professional at their work. I'm in the process of giving them the job of my other house that I have in Long Island New York. And their prices are very, very reasonable compared to other companies. I will definitely recommend.”
“George did an awesome job on our garage floor. He is fair, honest, and timely. He also leaves the site clean when complete.”
“Did an amazing job with our garage. Super professional and easy to work with. Highly recommend.”
Fill in your information below
USA Epoxy Floors is committed to satisfaction & excellence for every customer.
USA Epoxy Floors performs concrete repair in Denning for all types of slab flaws, cracks, joint splits, pits, and surface damage, across residential, industrial, and commercial properties. Each job starts with a technical site inspection and ends with mechanical prep and durable patching, leaving surfaces level and structurally sound.
View Service
USA Epoxy Floors rebuilds deteriorated concrete surfaces in Denning with full resurfacing, starting with detailed slab prep including grinding or blasting, followed by comprehensive repair. The renewed surface is left smooth and structurally ready for coatings, stain, polish, or direct use.
View Service
In Denning, polyurea floor installation by USA Epoxy Floors applies a fast-curing, high-strength resin over profiled concrete. The process uses industrial prep methods and a system that’s operational for Denning properties in hours, delivering dependable chemical and impact resistance for demanding local sites.
View ServiceSelect an area of interest to learn more
We provide listings of areas we serve. If you don't see your city, contact us to confirm.
